返回首页 | 加入收藏 | 关于我们 | 联系我们

欢迎光临济南广大铝业有限公司官网!

铝板生产厂家 铝卷良心企业

全国服务热线131-5601-1888
0531-87895188
当前位置:首页 » 济南铝板喷射清洗如何做好?

济南铝板喷射清洗如何做好?

文章出处:www.jngdly.com 责任编辑:admin 发表时间:2015-2-1 17:15:29

济南铝板http://www.jngdly.com/喷射清洗法的应用广泛,由于设备复杂,工艺要求较高,清洗效果不佳,那么如何做好工业铝型材喷射的清洗呢?

1、济南铝板喷射清洗需要加强工艺广利,严格执行操作规程,每天检查运行状态,时刻观察工艺参数,禁止工件停滞在设备中,以免生锈。
Jinan aluminum jet cleaning process needs to be strengthened Guangli, strict implementation of the rules, check the operation status of every day, always observe the process parameters, prohibit piece stuck in the device, to prevent

rust.

2、注意水洗质量。济南铝板为了减轻污染程度,首先应尽量减少工件夹带清洗液污染下道工序。另外应考虑多级水洗,一般为二级水洗,有的工艺还是用纯水洗。后一级水洗用水最大玷污不超过前一级清洗工件的十分之一,这样二级洗工件的残液浓度仅为原来浓度的,百分之一。在添加清水洗时,采用逆流补充,以节约用水。
Note water quality. Jinan aluminum in order to reduce pollution levels, the first piece should minimize entrainment cleaning fluid contamination under the procedure. It should also be considering multi-stage washing, usually two washing,

some process or with pure water. One of the largest pre-washed with water contamination does not exceed the level of the work is very clean after level, so the secondary wash only original piece of residue concentration concentration,

one percent. When you add water to wash, using countercurrent supplement to conserve water.

3、泡沫及其控制。济南铝板清洗剂的质量并不取决于泡沫的多少,而在往里喷射时,要求清洗剂是低泡的,否则批量生产就不能正常进行。
Foam and control. Jinan quality aluminum cleaning agent does not depend much foam, and in the inside injection, require cleaning agents are low foaming, otherwise mass production can not be normal.

4、除油剂的配方。由于单一组的清洗剂效果差,所以济南铝板http://www.jngdly.com/生产上一般采用多组分,复合型的清洗剂,因为由强碱,弱碱,聚合无机盐,表面活性剂等适当配合而成的符合清洗剂,能有地发挥各自的洗净特性,因而能显著地提高洗净效率。
Foam and control. Jinan quality aluminum cleaning agent does not depend much foam, and in the inside injection, require cleaning agents are low foaming, otherwise mass production can not be normal.

此文关键字:济南铝板