返回首页 | 加入收藏 | 关于我们 | 联系我们

欢迎光临济南广大铝业有限公司官网!

铝板生产企业 铝卷良心厂家

全国服务热线131-5601-1888
0531-87895188
当前位置:首页 » 济南铝卷如何进行裁剪?

济南铝卷如何进行裁剪?

文章出处:www.jngdly.com 责任编辑:admin 发表时间:2015-4-11 19:29:46

济南铝卷http://www.jngdly.com/进行裁剪是合金铝卷生产或使用的必经过程,而硅对硬质合金有腐蚀作用,虽然一般将超过12%Si的铝合金称为高硅铝合金,因此在生产济南铝卷时,一般厂家推荐使用金刚石刀具,但这也不是绝对的,硅含量逐渐增多对刀具的破坏力也逐渐加大,硅含量在8%至12%之间的铝合金是一个过渡区间,既可以使用普通硬质合金,也可以使用金刚石刀具。
Jinan is an alloy of aluminum coil aluminum coil cropping production or use of a necessary process, and silicon carbide have a corrosive effect on, although most will be more than 12% Si is called high-silicon aluminum alloy, so the production of aluminum in Jinan when the volume is generally recommended to use a diamond tool manufacturers, but this is not absolute, silicon content gradually increased the destructive power of the tool is gradually increasing silicon content aluminum alloy between 8-12% is a transition zone, either use ordinary carbide, diamond tools can also be used.
   
使用硬质合金制作济南铝卷http://www.jngdly.com/时,应使用经PVD方法、不含铝元素的、膜层厚度较小的刀具,因为PVD方法和小的膜层厚度使刀具保持较锋利的切削刃成为可能,而膜层材料含铝可能使刀片膜层与工件材料发生亲合作用而破坏膜层与刀具基体的结合,因为超硬镀层多为铝、氮、钛三者的化合物,可能会因硬质合金基体随膜层剥落时,少量剥落造成崩刃。
When using cemented carbide production Jinan aluminum coil, should be used by the PVD method, free of aluminum element, the smaller film thickness the tool, because the PVD methods and a small film thickness so that the tool holding

relatively sharp cutting edge as possible, the film material is an aluminum-containing layer may make the blade with the workpiece material and damage occurring binding affinity for the substrate film and the tool, because more ultra-hard coating of aluminum, nitrogen, titanium three compounds, may be due to carbide when coating substrates with peeling, flaking caused a small amount of chipping.
 


 

此文关键字:济南铝卷