返回首页 | 加入收藏 | 关于我们 | 联系我们

欢迎光临济南广大铝业有限公司官网!

铝板生产厂家 铝卷良心企业

全国服务热线131-5601-1888
0531-87895188
当前位置:首页 » 济南铝板压花机操作步骤介绍

济南铝板压花机操作步骤介绍

文章出处:www.jngdly.com 责任编辑:admin 发表时间:2015-4-19 16:52:20

1、先接通济南铝板http://www.jngdly.com/压花机的三相电源总开关,然后打开机台侧控制箱上的电源开关,如果有高周开关的,暂时不开,接着开电热电源开关,此时,真空管和热模都开始预热。
Jinan aluminum embossing machine was switched on three-phase power switch, and then turn on the power switch on the machine side of the control box, if there is high-cycle switch, temporarily not open, then open the electric power switch, this time, the vacuum tube and heat mold began to warm up.

2、在济南铝板压花机下模辅上绝缘物,上极端装上上模,开试模开关,开始调试上下模接合位置,如果下接合不好,就移动下模,如果水平不合,就调较上模的四支柱子。
Jinan aluminum die embossing machine before putting down insulation, installed on the extreme upper die, open tryout switch down to start debugging mode engaged position, if the next engagement is not good, move the lower die, if the level of irregularities, the adjustments four pillars of the child on the mold.

3、济南铝板压花机的模具调好后,调节时间控制器,下降时间即上模运行到压紧下模的时间,熔接时间即输出时间,冷却时间,即固化时间,上述三个时间需灵活应用,并无固定值数 。
Jinan embossing machine aluminum die after a good tune, adjust time controller, fall time that is running on the die to the die clamping time, welding time that the output time, cooling time, that the curing time, the three time to be flexible application There is no fixed number of values.

4、以上操作如已超过10-15分钟,且温度也达到所需时,把高周开关打上,开始操作测试。济南铝板http://www.jngdly.com/压花机成品的效果,由温度、同调功率输出、压力、输出高周时间四方面决定。
The above operation as more than 10-15 minutes, and when you reach the desired temperature, the high-cycle switch marked to begin operational testing. Jinan finished aluminum embossing machine effect, the temperature, the power output of the same tune, pressure, high-output four weeks aspects decision.

此文关键字:济南铝板