为确保济南铝板http://www.jngdly.com/的质量，我们需要用测量工具检测下新出的产品，但如果这些工具遭到损坏，对济南铝板就起不到监督控制作用。
1、济南铝板不要用油石、砂布擦磨量具表面及测量面和刻线部分，非计量检修人员，严禁拆卸、改装和擅自修理量具。量具的存放地点应保持清洁、干燥，无震动、无腐蚀性气体，且要远离温度变化范围大的地方或有磁场的地方。量具盒内存放的量具要清洁干燥，不准存放其他杂物。
Do Jinan aluminum oil stone, emery cloth and rub the surface gauges measuring surface and line section, the non-metering maintenance personnel, non-demolition, alteration and unauthorized repairs gauges. Measuring the storage location should be kept clean, dry, no vibration, no corrosive gas, and to stay away from large temperature changes of place or places where magnetic fields. Gage Gage storage box must be clean and dry, are not allowed to store other debris.
　
2、当济南铝板表面有毛刺时，一定要去净毛刺，再进行测量，否则会使量具磨损，并且还会影响测量结果的准确性。不要用手摸量具的测量面，因为手上有汗液等潮湿脏物会污染测量面，使它生锈。量具不要同其他工具、及金属物质混放在一起以免碰伤量具。
When Jinan aluminum surface burr burr must go to the net, and then measure, otherwise it would gage wear, and also affect the accuracy of the measurement results. Do not touch the gauge measuring surface, because the hands of a sweat and other moisture contamination measuring surface dirt will make it rust. Do not mix with other gauges on the instrument, and the metal material together so as not to bruise measuring tool.
　　
3、切忌把济南铝板卡尺的量爪尖端当作划针、圆规或其他工具使用，不准人为扭动两卡爪或把量具当卡板使用。
Avoid the Jinan aluminum caliper jaws as a stylus tip, compass or other tools, are not allowed to twist the two artificial jaw or the use of measuring tools when pallets.
　　
4、用完济南铝板http://www.jngdly.com/量具后，要擦干净表面污渍、铝屑，松开紧固装置，当长期不用时，在测量面要涂防锈油。量具在不用时，要将其放入保护盒内，最好专人专职使用，并做好量具经权威单位检测的年审记录。
After the run Jinan aluminum gauges, to wipe clean surface stains, aluminum scrap, loosen the fastening device, when the long-term need, measure the surface to be coated in rust oil. Gage when not, to put it in a protective case, it is

best to use full-time person, and make annual record Measuring unit detected by the authority.